I. NetWare Driver Installation Instructions

ͻ
 NETWARE.31	
ͼ
For : Netware V3.1

This subdirectory contains the NETWARE V3.1 device driver for IDE Cache
Controllers: IDENV31.DSK
The following steps explains the installation procedures.

For Single Card Installation

STEP 1 ==> Install the IDE Cache Controller
        . Remove other add-on cards that may conflict with IDE card's ROM
          space or interrupt
        . Select this card as the primary controller
        . Select the ROM space of the IDE cache card
	. Enable floppy diskette
STEP 2 ==> Plug in other add-on cards if necessary
STEP 3 ==> At the NETWARE server prompt: ":" 
STEP 4 ==> Type:    load IDENV31

Setting up Duplexing 

STEP 1 ==> Follow the instructions in \README\README.IDE - "Installing 2
           Tekram Cache Controllers in a System"
STEP 2 ==> Plug in other add-on cards if necessary
STEP 4 ==> At the NETWARE server prompt: ":" 
STEP 5 ==> Type:    load IDENV31     (for primary)
STEP 6 ==> Type:    load IDENV31     (for secondary)


ͻ
 NETWARE.31X	
ͼ
For : Netware V3.11
      Netware V3.12
      Netware SFT-III

This subdirectory contains the NETWARE V3.11, V3.12 and SFT-III device driver
for IDE cache controllers: IDENV31X.DSK. The installation procedure is the
same as V31, except the driver loaded here is IDENV31X.DSK.


ͻ
 NETWARE.40X	
ͼ
For : Netware V4.00
      Netware V4.01
      Netware V4.02
      Netware V4.1

This subdirectory contains the NETWARE V4.00/V4.01/4.02/4.1 device drivers
for IDE cache controllers IDENV40.DSK & IDENV40.DDI. Further installation
information can be found in NetWare manual.



